1 6

Little FOCer Rev3 ESC Electric Speed Controller - Standard

Little FOCer Rev3 ESC Electric Speed Controller - Standard

$325.00
$325.00
Sold Out

Little FOCer Rev3 ESC Electric Speed Controller - Standard

  • with Aluminum heat sink. 
  • Uses Vesc based firmware
  • Approximate Dimensions are: 3 and 3/8" x 3 and 3/8" x 1 and 1/8"
  • DC input 12 Gauge wire to XT60  Male
  • Phase Output 12 Gauge wire to 4mm Female Bullet connectors
  • On board IMU for balance applications 
  • Integrated Bluetooth NRF 52840 
  • DRV less design
  • Sophisticated fault detection for over-current, over-voltage, gate drive errors, and more
  • Easy On/Off capability with latching switch of choice
  • ESD Protected IO

 

New features in  Rev3:

  • Increase current limits
  • support for phase filters
  • ASS support (Advanced Sensorless Startup)

 


Specification Value
 Nominal Input Voltage 28V to 72V (8s to 20s Lithium Ion)
Recommended Lower voltage limit 24V
Absolute Maximum Operating Voltage 84V
Battery Current Consumption

Off=500µA

Idle< 0.8W

Max (ext.) = 100A
Peek Phase Current 250A
Peak Efficiency 95% or greater
PET PWM switching frequency range 10kHz to 60kHz (Center Aligned PWM)
Minimum recommended motor phase to phase inductance 10µH
Supported Motor Types BLDC and DC motors
Input Capacitance 602µF
Operating Ambient Temperature Range -20C to 50C
Storage Temperature Range -35C to 85C
Thermal Cutback The controller linearly reduces maximum output current when the internal controller temperature is above 80C. Complete cutoff at 100C, the control board over-temperature threshold
Communication Protocols 

1xCAN

1xUART 

1xBlutooth Low Energy
Gyroscope

On board IMU
Management Interfaces

USB Type-C

Bluetooth
Management Software

VESC 6 open source project compatible 

 

The Little FocFM V3 is based upon the VESC®-Project. VESC is a registered TM, owned by Benjamin Vedder